Hello My name is Serge, I like making How to Videos on Sprinter maintenance, now I have more videos about stuck Injectors and other ways of pulling them out, One thing a shifter is good for. This is what we have found works very well. You don’t know until you have dealt with brass seating washers. Patients, precis Fuel flow to injector pump is good. Plenty of flow. Verified by removing hose after the second filter and watching it while turning on key. The lift pump functions normally and both filters are new. The solenoid clicks when the key is turned to the ON position, and again when it turns OFF. When the key is turned on, the solenoid is in the OUT Fuel Injector stuck in Head. I am in the middle of a head gasket repair, and have gotten the passenger side head torn completely down, except for one thing, the #7 injector is stuck in the head. I've got the hold-down screw loose, and the hold down block itself will wiggle around, but the injector itself acts like it is frozen in the head. Removing stubborn injectors / How To Remove A stuck Diesel Injector. Removing stubborn injectors How To Remove A Diesel The stuck bad fix repair Seized Removal Common Rail Diesel Our mobile service provides the specialist service of extracting seized diesel injectors either with a hydraulic puller or by drilling with a 100% success rate. Common vehicles affected by seized or corroded diesel injectors are: Mercedes equipped with CDI engines, BMW’s, Peugeot, Citroen, Renault, Ford, Mazda, Nissan, Vauxhall, Volvo, Honda. Disconnect the fuel rail. Once you locate the fuel rail on the fuel injectors, go ahead and disconnect it. You should have an exposed hose to which you will connect the fuel injector cleaning tool later on. 3. Fill the fuel injector cleaning tool with a cleaning solution. Remove the cap of the fuel injector cleaning tool and add the cleaning Replied by STEPHEN on topic stuck plungers fuel pump. Ok, here is a pump with the plunger withdrawn, and the yoke (from a larger engine) so you can see how the yoke will slip off the plunger, and how the plunger will hopefully come out (eventually). You can see the two dowel holes on the base of the pump, you would have to lift the pump high dNdXFe.